進口SKODA活頂針用于在機床上夾持工件

進口skoda活頂針用于在機床上夾持工件
skoda活頂針csn 24 3319
用中孔角60°或90°夾持空心工件的精密活件中心
特殊密封防止工藝液和灰塵顆粒的進入。
根據客戶的要求,有廣泛的特殊設計選項.
增加工件生產組合的60度和90度插入件。
這些活頂針的設計是為了在必要的情況下,用大直徑的空腔夾住工件,而不能用傳統類型的活頂針夾住。
the rotating part of the live center is ended with a special taper - which enables to fit clamping insert with an angle 60 ° (u1) or 90 ° (u2) as needed. in the basic version, the live centers are supplied with one set of replaceable clamping inserts corresponding to the mt size.
in the standard version, the live centers are supplied with inserts as required with a maximum ø of d according to the table. in a special design, non-disassemble live centers are also supplied - the clamping inserts cannot be removed. the special clamping inserts are also supplied as spare parts. the live centers are provided with a morse taper shank according to Čsn standard iso 296.
the live centers are supplied with lithium-based grease mogul lv2-wr. disassembly of the live centers - except for authorized service - is not recommended.
skoda活頂針csn 24 3325
頭角60°或90°重工件夾持的精密活頂針
一種特殊的密封劑可以防止工藝液和灰塵顆粒的進入.
根據客戶要求進行特殊設計的可能性.
選擇兩個精確度-正常和額外。
有可能在研磨機上使用活頂針。